4.6.4 The Character Definition Arrays

to_lower[] and to_upper[] are simple arrays that hold the lowercase and uppercase characters corresponding to each member of the character set. For example:

to_lower['A'] should contain 'a'
to_upper['a'] should contain 'A'

sort_order[] is a map indicating how characters should be ordered for comparison and sorting purposes. Quite often (but not for all character sets) this is the same as to_upper[] (which means sorting will be case-insensitive). MySQL will sort characters based on the value of sort_order[character]. For more complicated sorting rules, see the discussion of string collating below. See section 4.6.5 String Collating Support.

ctype[] is an array of bit values, with one element for one character. (Note that to_lower[], to_upper[], and sort_order[] are indexed by character value, but ctype[] is indexed by character value + 1. This is an old legacy to be able to handle EOF.)

You can find the following bitmask definitions in `m_ctype.h':

#define _U      01      /* Uppercase */
#define _L      02      /* Lowercase */
#define _N      04      /* Numeral (digit) */
#define _S      010     /* Spacing character */
#define _P      020     /* Punctuation */
#define _C      040     /* Control character */
#define _B      0100    /* Blank */
#define _X      0200    /* heXadecimal digit */

The ctype[] entry for each character should be the union of the applicable bitmask values that describe the character. For example, 'A' is an uppercase character (_U) as well as a hexadecimal digit (_X), so ctype['A'+1] should contain the value:

_U + _X = 01 + 0200 = 0201

User Comments

Add your own comment.